Description
NOTE: If these scope mounts are out-of-stock, and you’d like to receive an email notification when they are back in stock, send an email to cody.christian@f3rmachine.com.
Precision CNC-machined, solid one-piece riflescope mount.
Featuring an integrally-machined recoil lug on the bottom rail surface for MIL-STD-1913 Picatinny rails, serialized/matched ring caps, flush-design rail clamps, chamfered bore edges, and Torx-Plus socket-head cap-screw fasteners. Each ring has 1.15″ of clamping surface, with six clamping screws, providing increased surface area without applying excess pressure to your rifle scope. The edge of the ring bores are chamfered to prevent damage to your scope.
Distance between rings is 2.65″. The 1.35″ height is measured from the rail surface on the bottom to the center of the scope tube bore. Each scope tube bore is machined in the same CNC operation, ensuring they are perfectly concentric and aligned with the bore of the rifle. A binary dot system of batch serial numbers are machined into the upper and lower ring halves before separation, ensuring you receive a matched set.
MOA mounts: when the recoil lug is towards the *rear* of the rifle, the mount is correctly tilted lower towards the front.
Machined from 6061 aluminum and Class III Type 2 hard anodized per MIL-A-8625. Weight: 9.5 oz
Karle (verified owner) –
This thing is a tank! Very well made and designed. Fit and finish is perfect. I only wish they made them in a lower height for a bolt rifle. These seem to be laid out with an AR platform in mind. But a big, solid mount like this makes more sense on a long range bolt gun. My rifle (56mm obj) has a 1/2″ gap between the scope and barrel. But only because it’s a bull barrel. Otherwise it would worse. Make a 1.1″ model and I’ll come back and give it a five!
Kenny Ey –
Absolutely one of the best mounts on the market. Built like a tank is an understatement. This scope mount holds up to harsh competition environments and serious falls. Keeping zero is the key factor to a good scope mount. This one does so while protecting the finish of your high end optic with perfect alignment between rings. Definitely recommend getting one or more at minimum
Leo –
Please make one in 1” scope height! Badly do I want to mount one of these beasts on my bolt rifles without stretching my neck to look through my scope.
Randall Carey –
Anyone knows if they work fine with Arken Optics? with the only rail width structural connection only the width of the Picatinny rail width it looks like it should work ok.. but that is why I ask.. not had one in hand. Thanks