Description
NOTE: If these scope mounts are out-of-stock, and you’d like to receive an email notification when they are back in stock, send an email to cody.christian@f3rmachine.com.
The 1.50″ height cantilever scope mounts are designed for rifles with full-length Picatinny/1913 rails extending from the action over the handguard, where the scope needs to elevated higher for the objective “bell” to clear the rail. The cantilever (2.15″ forward extension) enables the scope to be mounted further forward to allow for correct eye relief.
These precision CNC-machined, solid one-piece mounts are the best way to secure your expensive rifle scope to your firearm. Featuring an integrally-machined recoil lug on the bottom rail surface for MIL-STD-1913 Picatinny rails, serialized/matched ring caps, flush-design rail clamps, chamfered bore edges, and Torx-Plus socket-head cap-screw fasteners.
Each ring has 1.15″ of clamping surface, with six clamping screws, providing increased surface area without applying excess pressure to your rifle scope. The edge of the ring bores are chamfered to prevent damage to your scope.
Distance between rings is 2.65″. The 1.50″ height is measured from the rail surface on the bottom to the center of the scope tube bore. Each scope tube bore is machined in the same CNC operation, ensuring they are perfectly concentric and aligned with the bore of the rifle. A binary dot system of batch serial numbers are machined into the upper and lower ring halves before separation, ensuring you receive a matched set.
MOA mounts: when the recoil lug is towards the *rear* of the rifle, the mount is correctly tilted lower towards the front.
Machined from 6061 aluminum and Class III Type 2 hard anodized per MIL-A-8625.
Weight: 10.4 oz
20 MOA
Reviews
There are no reviews yet.